![]() Xinput -set-prop "SynPS/2 Synaptics TouchPad" "Device Accel Constant Deceleration" 1.5Īnd Put this in the start-up applications list. If you need to set this value automatically every time Ubuntu starts then: You may have to play around with this number a bit to set it exactly as you need. Xinput -set-prop 11 267 1.5 where 11 is the device, just like from above, 267 is the id of the device property (Device Accel Constant Decleration) as you can see when device 11 is being listed all of properties being attached, and finally 1.5 is your desired speed. Using this command: xinput -set-prop "SynPS/2 Synaptics TouchPad" "Device Accel Constant Deceleration" 1.5 Now reduce it's property values to suit your need: Device Accel Constant Deceleration (267): 2.500000 The trick is to scale back Apples acceleration curve usually to the third from last tick mark. Xinput -list-props 11 as 11 is the number that is shown above in its parent property (SynPS/2 Synaptic TouchPad). Navigate one to the default Apple mouse tracking speed page, and the other one to the mouse’s proprietary setting page (like Microsoft, Logitech, etc.). NOTE: Safe Mode boot can take up to 10 minutes as it's doing the following Verifies your startup disk and attempts to repair directory issues, if needed. ![]() To list out device properties: xinput -list-props "SynPS/2 Synaptics TouchPad" Boot into Safe Mode according to Start up your Mac in safe mode - Apple Support and reset the mouse Tracking Speed in the System/Mouse/Point & Click preference pane. ![]() My pointing devices are a Logitech USB RECEIVER and a Synaptics TouchPad. Open a terminal and run this command: xinput -list -short First we need to identify the input device ID to change the speed/sensitivity.
0 Comments
Leave a Reply. |